Verifying AWS Configurations

To verify interface configurations, use the following CLI commands (refer to the CLI Command Reference Guide for more information):

Table 1: Verify interface configurations
vCore CLI (Mode) & Command	Purpose
JATP (diagnosis)# setupcheck all	Run a check of all system components
JATP (server)# show interface	Verify interface connectivity and status
JATP (server)# show ip <interface>	Verify traffic [example: show ip eth1]
JATP (server)# ping x.x.x.x	Ping connected devices.
JATP (server)# show ip	Display AWS public and private IP addresses.

Note:

Be sure to refer to the Juniper ATP Appliance CLI Command Reference for more information.