Configuring T1 and E1 Port Parameters for CTP Bundles (CTPView)
This topic describes how to configure port parameters for T1/E1 interfaces.
Before you begin:
Log in to the CTPView software at least at the Net_Admin level.
Connect the CTPView server to the CTP device for which you want to configure bundles.
To configure T1 and E1 port parameters for CTP bundles using CTPView:
Field | Function | Your Action |
---|---|---|
Port Description |
Specifies a description for the port. |
Enter a description of up to 64 alphanumeric characters. Do not use the following characters: ( ; ' " ) ] |
I/F Type |
Specifies the daughter card as the interface type. |
Select DCARD. |
T1/E1 Choice |
Specifies the type of interface. |
Select one:
|
Fractional |
Specifies whether the card is fractional. |
Select one:
|
T1 Line Coding |
For T1 interfaces, specifies the T1 encoding method used on this bundle. |
Select one:
|
Framing Mode |
For fractional T1, ESF is the only option supported. With ESF framing, the frame synchronization, data link, and CRC framing bits are passed across the IP network untouched. |
|
Fractional Frame Transport |
For fractional T1, enable or disable fractional frame transport. |
Select one:
|
E1 Connector Type |
For E1 interfaces, configure the termination to work with either coaxial or RJ-48. |
Select one:
|
Number of Channels |
Specifies the number of fractional T1 or E1 channels to transport. |
For T1, select a number from 1 through 24. For E1, select a number from 1 through 31. |
Signaling |
Specifies the signaling method used for fractional E1. |
Select one:
|
Clock Cfg |
Specifies the type of clocking for the port. The default value for Clock Cfg is CTP is Loop Timed. |
Select one:
|