Selecting the Type of Clocking on Serial Ports for CTP Bundles (CTP Menu)
This topic describes how to select the type of clocking that you want to use on serial ports. The type of clocking supported depends on the type of encoding you are using.
Before you begin:
Disable the bundle before you modify the bundle options.
CTP Menu gives you the option of selecting the clocking type when you change the interface encoding for a circuit. You can also specify the clocking type for CTP bundles using the CTP Menu as follows:
- From the CTP Main Menu, select 1) Bundle Operations.
- Select 1) CTP.
- Select a bundle from the list.
If you select an active bundle, you are prompted to disable the bundle before configuring it.
- Select 3) Port Config.
- Select 3) Clock Config.
- Select 1) Port Clock Config.
- Configure the options as described in Table 1.
Encoding Type | Clocking Type Supported |
---|---|
NRZ and TDM with interface mode set to DCE |
You can specify the following clocking methods for NRZ and TDM circuits with DCE mode specified:
|
NRZ and TDM with interface mode set to DTE |
You can specify the following clocking methods for NRZ and TDM circuits with DTE mode specified:
|
ISOCH |
You can specify the following clocking methods for ISOCH circuits:
|
CDI |
You can specify the following clocking methods for CDI circuits:
|
TRANS |
You can specify the following clocking methods for TRANS circuits:
|