Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
 

Update Logical Links and LAG Mode

You can update Link Labels of existing leaf-generic system links.

You can also change the LAG mode between leafs and generic systems. For example, you may have a dual-connected generic system configured with LACP, and you want it to have separate, individually configured Layer 2 links. You can change the LAG mode (such as LACP (Active)) to No LAG. When you change the LAG mode to No LAG, you must change the Link Label for all affected links, or you will receive an error.

CAUTION:

Changing Link Labels results in the loss of all virtual network assignments for the port(s). You'll need to re-assign them. If you want to change a dual-connected generic system to No LAG, we recommend that you only change the second Link Label value to retain virtual network assignments on the first port.

You can also change to a LAG mode from No LAG. With the same procedure as above set all the links in the same group to the same Link Label, and change the LAG mode.

To update logical links and LAG modes follow the steps below:

  1. From the blueprint, navigate to Staged > Physical > Topology and make a selection.
  2. Click Edit links, then click Update logical links and LAG Mode.
  3. Change the link labels, LAG modes and/or tags, as needed.
    • To change one link, change the Link Label and/or select a different LAG mode from the drop-down list for that link.
    • To change multiple links, select one or more links, make your changes in the sections that appear above the table, then click Apply to selection.
  4. Click Update to stage the change and return to the links view.