Override Cabling (GUI)

Situations when you might want to edit the cabling map include:

to use existing network cabling instead of recabling to the Apstra-prescribed cabling
to change interface names or IP addresses in the existing network cabling map
to specify a different port from the one that the Apstra cabling algorithm selected
to avoid the use of a defective interface

Device profiles must be assigned to blueprint nodes.

CAUTION:

Overriding Apstra-generated cabling can be disruptive to the network. Use with extreme caution. For assistance with production networks, please contact Juniper Support.

From the blueprint, navigate to Staged > Physical > Links and click the Edit cabling map button (third of five buttons above the links list).
Change interface names and/or IP addresses, as applicable.
You can use Batch clear override to clear all Interface and IPv4/IPv6 values for a specific device type.
Note:
To drop the override for either an interface name or IPv4/IPv6 address, submit an empty value in the corresponding field.
Click Update to stage the changes.
Click Uncommitted to see the diffs between Staged and Active.
Click the Commit button to save the changes to the Active Blueprint.