Access Port and Uplink Port LEDs on a QFX3600 or QFX3600-I Device

Each access port and uplink port in a QFX3600 device has two LEDs (see Figure 1).

Figure 1: LEDs on the QSFP+ Access and Uplink Ports

The LEDs labeled Link/Activity LED in Figure 1 indicate link activity or faults. The LEDs labeled Status LED in Figure 1 indicate link status.

Table 1 describes the QSFP+ access port LEDs.

Table 1: Access Port LEDs on QSFP+ Ports on a QFX3600 Device
LED	Color	State	Description
Link/Activity	Unlit	Off	No link is established, there is a fault, or the link is down. Note: The LED remains unlit only if all four of the 10-Gigabit Ethernet SFP+ breakout links are down.
	Green	On steadily	A link is established, but there is no link activity. Note: The LED is lit green when at least one of the four 10-Gigabit Ethernet SFP+ breakout links is established.
	Green	Blinking	A link is established, and there is link activity. Note: The LED is lit green when at least one of the four 10-Gigabit Ethernet SFP+ breakout links is established.
Status	Unlit	Off	No transceiver is installed in the port, or the transceiver is not supported.
Status	Green	On steadily	A transceiver is installed in the port.

Table 2 describes the QSFP+ uplink port LEDs.

Table 2: Uplink Port LEDs on a QFX3600 or QFX3600-I Device
LED	Color	State	Description
Link/Activity	Unlit	Off	No link is established, there is a fault, or the link is down.
	Green	On steadily	A link is established, but there is no link activity.
	Green	Blinking	A link is established, and there is link activity.
Status	Unlit	Off	No transceiver is installed in the port, or the transceiver is not supported.
Status	Green	On steadily	A transceiver is installed in the port.