SRX340 Power System
Understanding the SRX340 Firewall Power Supply
The SRX340 Firewall uses a fixed, internal AC power supply. The power supply distributes the different output voltages to the device components according to their voltage requirements. The power supply is fixed in the chassis and is not field-replaceable. The power supply has a single AC appliance inlet that requires a dedicated AC power feed.
See Also
SRX340 Firewall Power Specifications and Requirements
The AC power system electrical specifications for the SRX340 Firewall are listed in Table 1.
Power Requirement |
Specification |
|---|---|
AC input voltage |
100 to 240 VAC |
AC input line frequency |
50 to 60 Hz |
AC system current rating |
1 to 1.5 A |
Maximum AC inrush current |
7.3 A at 220 V/50 Hz (with four Mini-PIMs installed) |
The AC power cord for the services gateway is intended for use with the device only and not for any other use.
SRX340 Firewall Supported AC Power Cords
The AC power cord for the services gateway is intended for use with the services gateway only and not for any other use.
In North America, AC power cords must not exceed 4.5 m (approximately 14.75 ft) in length, to comply with National Electrical code (NEC) Section 400-8 (NFPA 75, 5-2.2) and 210-52, and Canadian Electrical Code (CEC) Section 4-010(3).
Table 2 provides power cord specifications, and Figure 1 depicts the plug on the AC power cord provided for each country or region.
Country |
Electrical Specification |
Plug Standards |
|---|---|---|
Australia |
250 VAC, 10 A, 50 Hz |
AS/NZ 3112-1993 |
China |
250 VAC, 10 A, 50 Hz |
GB2099.1 1996 and GB 1002 1996 (CH1-10P) |
Europe (except Italy and United Kingdom) |
250 VAC, 10 A, 50 Hz |
CEE (7) VII |
Italy |
250 VAC, 10 A, 50 Hz |
CEI 23-16/VII |
Japan |
125 VAC, 12 A, 50 or 60 Hz |
JIS 8303 |
North America |
125 VAC, 10 A, 60 Hz |
NEMA 5-15 |
United Kingdom |
250 VAC, 10 A, 50 Hz |
BS 1363A |
Power cords and cables must not block access to services gateway components or drape where people might trip on them.