Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
 

Disconnecting the Alarm Relay Wires from the MX2020 Craft Interface

To disconnect the alarm relay wires from the router and an alarm-reporting device (see Figure 1):

  1. Disconnect the existing wire at the external device.
  2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
  3. Using a 2.5 mm flat-blade screwdriver, loosen the small screws on the face of the terminal block and remove the block from the relay contact.
  4. Using the 2.5 mm flat-blade screwdriver, loosen the small screws on the side of the terminal block. Remove existing wires from the slots in the front of the block (see Table 1).
Figure 1: Alarm Relay ContactsAlarm Relay Contacts
Table 1: Alarm Relay Contacts on the Craft Interface

Function No.

Label

Description

1

MINOR ALARM—[NC C NO]

MAJOR ALARM—[NC C NO]

The alarm relays consist of three terminal contacts with a normal closed (NC), common (C), and normal open (NO) relays that signal a minor or major alarm when broken.

Related Documentation