Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
 

Installing the MX2010 Extended DC Cable Manager

To install the extended DC cable manager (see Figure 1):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
  2. Position the extended DC cable manager over the two slots located on both sides of the DC PDM.
  3. Lift the extended DC cable manager slightly up while inserting the two flanges into the slots on both sides of the DC PDM.
  4. Push the extended DC cable manager into place.
  5. Tighten the two captive screws to secure the extended DC cable manager.
Figure 1: Installing the Extended DC Cable ManagerInstalling the Extended DC Cable Manager

To install the extended cable manager for the DC PDM (240 V China) or the universal (HVAC/HVDC) PDM (see Figure 2):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.

  2. Position the cable manager over the two slots located on both sides of the PDM.

  3. Lift the cable manager slightly up while inserting the two flanges into the slots on both sides of the PDM.

    Figure 2: Installing the Extended Rear Cable Manager on the DC PDM (240 V China) and Universal (HVAC/HVDC) PDMInstalling the Extended Rear Cable Manager on the DC PDM (240 V China) and Universal (HVAC/HVDC) PDM

  4. Push down to secure the extended cable manager in place. Tighten the screws using a screwdriver. See Figure 2.