MX2010 Component LEDs on the Craft Interface

MX2010 Host Subsystem LEDs and Buttons on the Craft Interface

Each host subsystem has three LEDs, located in the upper middle of the craft interface, that indicate its status. The LEDs labeled RE0 show the status of the Routing Engine on the CB-RE in slot 0. The LEDs labeled RE1 show the status of the Routing Engine on the CB-RE in slot 1. Table 1 describes the functions of the host subsystem LEDs.

Table 1: Host Subsystem LEDs on the Craft Interface
Label	Color	State	Description
MASTER	Green	On steadily	Host is functioning as the primary.
ONLINE	Green	On steadily	Host is online and is functioning normally.
OFFLINE	Red	On steadily	Host is installed but the Routing Engine on the CB-RE is offline.
OFFLINE	–	Off	Host is not installed.

When placing the CB-RE offline, the Routing Engine goes offline. The Routing Engine gets powered by the Control Board.

MX2010 Power Supply Module LEDs on the Craft Interface

Each Power Supply Module (PSM) has one bicolor LED on the craft interface that indicates its status. The LEDs, labeled 0 through 8, are located on the upper left of the craft interface next to the PSM label. Table 2 describes the functions of the PSM LEDs on the craft interface.

Table 2: Power Supply Module LEDs on the Craft Interface
Label	Color	State	Description
PSM	Green	On steadily	PSM is functioning normally.
PSM	Red	On steadily	PSM module has failed or power input has failed.

MX2010 Line-Card LEDs and Buttons on the Craft Interface

Each line card (MPC) has one bicolor LED on the craft interface that indicates its status. The LEDs, labeled 0 through 9, are located along the bottom of the craft interface. Table 3 describes the functions of the LEDs.

Table 3: Line-Card LEDs on the Craft Interface
Label	Color	State	Description
OK	Green	On steadily	Line card functioning normally.
	Green	Blinking	Line card is transitioning online or offline.
	–	Off	The slot is not online.
FAIL	Red	On steadily	Line card has failed.

There are ten push buttons located next to each of the line cards on the craft interface. These buttons are used to place the line cards online or offline. When a line card is inserted into an adapter card, and installed into the MX2010 router, the online/offline buttons can turn both cards on or off.

Note:

When installing an adapter card without the line card, the online/offline buttons have no affect.

MX2010 SFB LED and Buttons on the Craft Interface

Each SFB has one tricolor LED on the craft interface that indicates its status. The SFB LED, labeled 0 through 7, are located along the bottom of the craft interface. Table 4 describes the functions of the SFB LED.

Table 4: SFB LED on the Craft Interface
Label	Color	State	Description
OK	Green	On steadily	SFB functioning normally.
	Green	Blinking	SFB is transitioning online or offline.
	–	Off	The slot is not online.
FAIL	Red	On steadily	SFB has failed.

There are eight push buttons located next to each of the SFBs on the craft interface. These buttons are used to place the SFBs online or offline.

MX2010 Fan Tray LEDs on the Craft Interface

The fan tray LEDs, labeled 0 through 3, are located on the top middle of the craft interface. Table 5 describes the functions of the fan tray LEDs.

Table 5: Fan LEDs on the Craft Interface
Label	Color	State	Description
FAN TRAY	Green	On steadily	Fan is functioning normally.
FAN TRAY	Red	On steadily	Fan in a fan tray has failed. Fan tray has failed.

ON THIS PAGE