JRR200 Management and Console Port Connector Pinout Specifications
Management Port Connector Pinout Information for the JRR200 Route Reflector
The port on the front panel labeled MGMT is an autosensing 10/100/1000-Mbps Ethernet RJ-45 receptacle that accepts an Ethernet cable for connecting the JRR200 Route Reflector to a management LAN (or other device that supports out-of-band management). Two LEDs on the port indicate link activity on the port and the administrative status of the port.
Table 1 provides the pinout information for the RJ-45 connector for the management port. An RJ-45 cable, with a connector attached, is supplied with the JRR200 route reflector.
Pin |
Signal |
---|---|
1 |
TX+ |
2 |
TX- |
3 |
RX+ |
4 |
Termination network |
5 |
Termination network |
6 |
RX- |
7 |
Termination network |
8 |
Termination network |
Console Port Connector Pinout Information for the JRR200 Route Reflector
The console port is an RS-232 serial interface that uses an RJ-45 connector to connect to a console management device. The default baud rate for the console port is 9600 baud.
Table 2 provides the pinout information for the RJ-45 console connector. An Ethernet cable that has an RJ-45 connector at either end and an RJ-45 to DB-9 serial port adapter are supplied with the route reflector.
Pin |
Signal |
Description |
---|---|---|
1 |
RTS |
Request to Send |
2 |
DTR |
Data Terminal Ready |
3 |
TXD |
Transmit Data |
4 |
Ground |
Signal Ground |
5 |
Ground |
Signal Ground |
6 |
RXD |
Receive Data |
7 |
DSR/DCD |
Data Set Ready |
8 |
CTS |
Clear to Send |