AP45 Components and Specifications

Figure 1 shows the components on the AP45.

Figure 1: AP45 Components Reset button, USB port, Ethernet port for wired connections, and Ethernet port with Power over Ethernet on a networking device.

Reset button, USB port, Ethernet port for wired connections, and Ethernet port with Power over Ethernet on a networking device.

Table 1: AP45 Components
Component	Description
Reset	A pinhole reset button that you can use to reset the AP configuration to the factory default. See Reset an AP to the Factory-Default Configuration.
Eth0+PoE	100/1000/2500/5000BASE-T RJ-45 port that supports an 802.3at or 802.3bt PoE-powered device
Eth1	10/100/1000BASE-T RJ-45 port + 802.3af power sourcing equipment (PSE) (if PoE-in is 802.3bt)
USB	USB 2.0 port
Antenna connectors (available only in AP45E models)	Two pluggable antenna connectors: 2.4/5 (4 pin), 6+Scan (6 pin)
Status LED	A multicolor status LED to indicate the status of the AP and to help troubleshoot issues. See Troubleshoot a Juniper Access Point.

For AP45 specifications, see the AP45 Datasheet.