AP41 Components and Specifications

Figure 1 shows the components on the AP41.

Figure 1: AP41 Components Back panel of a networking device with Kensington Lock, Reset Button, USB Port, 12VDC Power Input, IoT Connector, Module Port, Eth1 Ethernet Port, and Eth0+PoE Ethernet Port.

Back panel of a networking device with Kensington Lock, Reset Button, USB Port, 12VDC Power Input, IoT Connector, Module Port, Eth1 Ethernet Port, and Eth0+PoE Ethernet Port.

Table 1: AP41 Components
Component	Description
Reset	A pinhole reset button that you can use to reset the AP configuration to the factory default. See Reset an AP to the Factory-Default Configuration.
USB	USB 2.0 port
12VDC	Input for an optional 12 VDC power supply. You must order this power supply (part number: DC-01) separately.
IoT	8-pin port for digital input and output, analog input, and ground
Module	10/100/1000BASE-T RJ-45 port
Eth1	10/100/1000BASE-T RJ-45 port
Eth0 + PoE	10/100/1000BASE-T RJ-45 port that supports an 802.3at PoE-powered device
Antenna connectors (available only in AP41E models)	Two reverse-polarity SubMiniature version A (RP-SMA) connectors
Kensington lock slot	Slot for a Kensington-style lock that you can use to secure the AP
Status LED	A multicolor status LED to indicate the status of the AP and to help troubleshoot issues. For information about the status LED, see Troubleshoot a Juniper Access Point.

For AP41 specifications, see the AP41 Datasheet.