[an error occurred while processing this directive][an error occurred while processing this directive]

Restarting the SBC Configuration Process

Caution: We recommend that you do not restart the software process unless instructed to do so by a Juniper Networks customer support engineer. A restart might cause the router to drop calls and interrupt transmission.

Three options are available when you restart the SBC configuration process:

  • gracefully—Restart the software process after calls have ended.
  • immediately—Immediately restart the software process.
  • soft—Reread and reactivate the configuration without completely restarting the software process.

To restart the SBC configuration process, enter the restart sbc-configuration-process command in operational mode:

user@host> restart sbc-configuration-process

When you restart the SBC configuration process, the process is stopped and then restarted.


Published: 2010-04-13

[an error occurred while processing this directive]