Technical Documentation

Configuring a Static or Dynamic VLAN Subscriber Interface over Aggregated Ethernet

You can configure a subscriber link represented by a static virtual LAN (VLAN) stacked on an aggregated Ethernet logical interface.

You can configure subscriber management services such as firewall filters and CoS for this subscriber interface.

To configure a subscriber interface using a static VLAN interface over an aggregated Ethernet logical interface:

  1. Configure the aggregated Ethernet interface.
    1. Configure the number of aggregated Ethernet interfaces on the router.

      See Configuring the Number of Aggregated Ethernet Interfaces on the Device.

    2. Configure the aggregated Ethernet interface.

      See Configuring an Aggregated Ethernet Interface.

    3. (Optional) Configure LACP.

      See Configuring Aggregated Ethernet LACP.

    4. (Optional) Configure the minimum number of links.

      See Configuring Aggregated Ethernet Minimum Links.

    5. (Optional) Configure the link speed.

      See Configuring Aggregated Ethernet Link Speed.

    6. (Optional) Configure the aggregated Ethernet logical interface to support one-to-one active/backup link redundancy or traffic load balancing.

      See Configuring Aggregated Ethernet Link Protection.

      Note: Link protection is required if you want to configure hierarchical CoS on the aggregated Ethernet interface. For more information, see Configuring Hierarchical CoS for a Subscriber Interface of Aggregated Ethernet Links.

  2. Configure the static or dynamic VLAN interface.
  3. Configure subscriber management services on the subscriber interface.

Published: 2010-04-15