[an error occurred while processing this directive][an error occurred while processing this directive]

Configure a Local Loopback

Purpose

Because ATM interfaces can be either SONET or T3, you use the sonet-options or t3-options statements to configure a local loopback. Figure 1 illustrates a local loopback configured for an ATM interface.

Figure 1: Local Loopback

Image h1960.gif

Action

To configure a local loopback without physically connecting the transmit port to the receive port, follow these steps:

  1. In configuration mode, go to the following hierarchy level:
    [edit]user@host# edit interfaces interface-name (sonet-options | t3-options)
  2. Configure the loopback:
    [edit interfaces interface-name (sonet-options | t3-options)]user@host# set loopback local
  3. Verify the configuration:
    user@host# show

    For example:

    [edit interfaces (t3-1/0/0 t3-options)]user@host# show loopback local;
  4. Commit the change:
    user@host# commit

    For example:

    [edit interfaces t3-1/0/0 t3-options]user@host# commit commit complete

Meaning

When you create a local loopback, you create an internal loop on the interface being tested. A local loopback loops the traffic internally on that PIC. A local loopback tests the interconnection of the PIC but does not test the transmit and receive ports.

Note: Remember to delete the loopback statement after completing the test.


Published: 2010-01-29

[an error occurred while processing this directive]