[an error occurred while processing this directive][an error occurred while processing this directive]

VPN Operational Mode Commands

Table 1 summarizes the command-line interface (CLI) commands you can use to monitor and troubleshoot Layer 2 circuits, Layer 2 virtual private networks (VPNs), virtual private LAN service (VPLS), and Layer 3 VPNs. Commands are listed in alphabetical order.

Table 1: Layer 2 Circuit, Layer 2 VPN, and VPLS Operational Mode Commands

Task

Command

Clear MAC address entries from the VPLS table.

clear vpls mac-address

Clear MAC addresses from the VPLS table.

clear vpls mac-table

Manually trigger a switch from the active pseudowire to the redundant pseudowire.

request l2circuit-switchover

Display Layer 3 dynamic tunnel database information.

show dynamic-tunnels database

Display Layer 2 circuit information.

show l2circuit connections

Display Layer 2 VPN information.

show l2vpn connections

Display multicast VPN c-multicast route information.

show mvpn c-multicast

Display multicast VPN instance information.

show mvpn instance

Display multicast VPN neighbor information.

show mvpn neighbor

Display virtual private LAN service (VPLS) information.

show vpls connections

Display the pending events in the level 2 address learning process (l2ald) routing socket code (rtsock) update queue.

show vpls flood event-queue

Display VPLS information related to the level 2 address learning process for the specified routing instance.

show vpls flood instance

Display VPLS route information related to the level 2 address learning process.

show vpls flood route

Display learned VPLS MAC address information.

show vpls mac-table

Display VPLS statistics.

show vpls statistics

Note: For information about how to configure Layer 2 circuits, Layer 2 VPNs, VPLS, and Layer 3 VPNs, see the JUNOS VPNs Configuration Guide.


Published: 2010-04-28

[an error occurred while processing this directive]