[an error occurred while processing this directive][an error occurred while processing this directive]

Service Sets Operational Mode Command

Table 1 summarizes the command-line interface (CLI) commands you can use to monitor and troubleshoot service sets. Commands are listed in alphabetical order.

Table 1: Service Sets Operational Mode Commands

Task

Command

Clear service sets statistics.

clear services service-sets statistics packet-drops

Display service sets CPU utilization.

show services service-sets cpu-usage

Display services sets memory utilization.

show services service-sets memory-usage

Display service sets statistics.

show services service-sets statistics packet-drops

Display services sets TCP maximum segment size (MSS) statistics.

show services service-sets statistics tcp-mss

Display service sets summary information.

show services service-sets summary

Note: Service sets are supported on the adaptive services interface on the following routers:

  • J Series routers—sp-pim/0/slot
  • M Series and T Series routers—ms-fpc/pic/port or sp-fpc/pic/port

Service sets are also supported on the redundant adaptive services interface (rspnumber) on M Series and T Series routers.

Note: For information about how to configure service sets, see the JUNOS Services Interfaces Configuration Guide.


Published: 2010-04-28

[an error occurred while processing this directive]