Technical Documentation

PTSP Operational Mode Commands

Table 1 summarizes the command-line interface (CLI) commands you can use to monitor and troubleshoot the packet-triggered subscribers and policy control (PTSP) services. Commands are listed in alphabetical order.

Table 1: PTSP Operational Mode Commands

Task

Command

Clear the packet-triggered subscriber session and log out the specified subscriber.

clear services subscriber sessions

Display bandwidth information about the packet-triggered subscribers.

show services subscriber bandwidth

Display information about the active dynamic policies applied to the specific subscribers.

show services subscriber dynamic-policies

Display information about the data flows associated with the specific subscriber.

show services subscriber flows

Display information about the active packet-triggered subscriber sessions on the router.

show services subscriber sessions

Display information about the data traffic statistics for the specified packet-triggered subscriber and for each service rule attached to that subscriber.

show services subscriber statistics

Note: PTSP services are supported on the MultiServices Dense Port Concentrator (MS-DCP) on the MX Series routers.

Note: For information about how to configure the PTSP services, see the JUNOS Subscriber Access Configuration Guide.


Published: 2010-04-28