[an error occurred while processing this directive][an error occurred while processing this directive]

PPPoE Interface Operational Mode Commands

Table 1 summarizes the command-line interface (CLI) commands that you can use to monitor and troubleshoot Point-to-Point Protocol over Ethernet (PPPoE) interfaces. Commands are listed in alphabetical order.

Table 1: PPPoE Interfaces Operational Mode Commands

Task

Command

Clear PPPoE sessions.

clear pppoe sessions

Clear PPPoE session statistics.

clear pppoe statistics

Display interface-specific information about PPPoE-configured interfaces.

show interfaces (PPPoE)

Display session-specific information about PPPoE-configured interfaces

show pppoe interfaces

Display PPPoE service name table information.

show pppoe service-name-tables

Display PPPoE active session information.

show pppoe sessions

Display PPPoE session statistics.

show pppoe statistics

Display PPPoE underlying interface information.

show pppoe underlying-interfaces

Display PPPoE version information.

show pppoe version

Note: PPPoE interfaces are supported on Fast Ethernet and ATM-over-ADSL and ATM-over-SHDSL interfaces on the J Series routers. PPPoE interfaces connect multiple PPPoE-client hosts on an Ethernet LAN to a remote site through a J Series Services Router. The J Series router can only be configured as a PPPoE client. Hosts share a common digital subscriber line (DSL), a cable modem, or a wireless connection to the Internet. For information about how to configure PPPoE interfaces, see the J Series Services Router Basic LAN and WAN Access Configuration Guide or the JUNOS Network Interfaces Configuration Guide.

For information about monitoring and troubleshooting Fast Ethernet interfaces, see Ethernet Interface Operational Mode Commands.

For information about monitoring and troubleshooting ATM-over-ADSL and ATM-over-SHDSL, interfaces, see ATM Interface Operational Mode Commands.


Published: 2010-04-28

[an error occurred while processing this directive]