[an error occurred while processing this directive][an error occurred while processing this directive]

Packet Gateway Control Protocol Operational Mode Commands

Table 1 summarizes the Packet Gateway Control Protocol (PGCP) command-line interface (CLI) commands you can use to monitor and troubleshoot the PGCP service that is used for the border gateway function (BGF) feature. Commands are listed in alphabetical order.

Table 1: PGCP Services Operational Mode Commands

Task

Command

Clear gates on a virtual BGF.

clear services pgcp gates

Clear statistical information.

clear services pgcp statistics

Display information about the configuration for a virtual BGF.

show services pgcp active-configuration

Display in-depth information about a particular gate on a virtual BGF.

show services pgcp gate

Display summary information about all gates on a virtual BGF.

show services pgcp gates

Display information about H.248 root terminations.

show services pgcp root-termination

Display information about BGF statistics.

show services pgcp statistics

Display information about conversations.

show services pgcp conversations

Display information about flows.

show services pgcp flows

Display summary information about terminations.

show services pgcp terminations

PGCP services are supported on Adaptive Services (AS) PICS, Multiservices (sp-fpc/pic/port) PICS, and the Multiservices Dense Port Concentrator (MS-DPC) on the following routers:

  • Juniper Networks M120 Multiservice Edge Router
  • Juniper Networks M320 Multiservice Edge Router
  • Juniper Networks T640 Core Router

Note: For information about how to use PGCP services to monitor the BGF feature, see the JUNOS Multiplay Solutions Guide.


Published: 2010-04-28

[an error occurred while processing this directive]