[an error occurred while processing this directive][an error occurred while processing this directive]

Network Address Translation Operational Mode Commands

Table 1 summarizes the command-line interface (CLI) commands you can use to monitor and troubleshoot Network Address Translation (NAT) services.

Table 1: NAT Operational Mode Commands

Task

Command

Display information about NAT address and port mappings.

show services nat mapping

Display information about NAT pools.

show services nat pool

Note: NAT is supported on the adaptive services interface on the following routers:

  • J Series routers—sp-pim/0/slot
  • M Series and T Series routers—sp-fpc/pic/port

NAT is also supported on the redundant adaptive services interface (rspnumber) on M Series and T Series routers.

Note: For information about how to configure NAT services, see the JUNOS Services Interfaces Configuration Guide.


Published: 2010-04-28

[an error occurred while processing this directive]