[an error occurred while processing this directive][an error occurred while processing this directive]

LDP Operational Mode Commands

Table 1 summarizes the command-line interface (CLI) commands you can use to monitor and troubleshoot the Label Distribution Protocol (LDP). Commands are listed in alphabetical order.

Table 1: LDP Operational Mode Commands

Task

Command

Clear LDP neighbors.

clear ldp neighbor

Clear LDP sessions.

clear ldp session

Clear LDP statistics.

clear ldp statistics

Display entries in the LDP database.

show ldp database

Display forwarding equivalence class filters.

show ldp fec-filters

Display the status of interfaces on which LDP is running.

show ldp interface

Display LDP neighbors.

show ldp neighbor

Display the configured named paths that are used by LDP.

show ldp path

Display LDP routing table entries.

show ldp route

Display currently active LDP sessions.

show ldp session

Display LDP statistics.

show ldp statistics

Display LDP traffic statistics.

show ldp traffic-statistics

Note: For more LDP-related commands, such as show route protocol, show route instance, and show route table, see Protocol-Independent Routing Operational Mode Commands.

For information about how to configure LDP, see the JUNOS MPLS Applications Configuration Guide.


Published: 2010-04-28

[an error occurred while processing this directive]