Technical Documentation

Analyzer Table

The jnxAnalyzerTable, whose object identifier is {jnxAnalyzerMIBObjects 1}, contains information about analyzer parameters. Each jnxAnalyzerEntry contains the objects listed in Table 1.

Table 1: jnxAnalyzerTable


Object ID



jnxAnalyzerEntry 1

Uniquely identifies an analyzer configured on the switch.


jnxAnalyzerEntry 2

Shows whether mirroring is enabled or disabled on the analyzer.


jnxAnalyzerEntry 3

Specifies the mirroring ratio. This object defines the sample size for mirroring. For example, 1 out of every x packets, where x is a number in the range of 1 through 2047.


jnxAnalyzerEntry 4

Specifies the loss priority for a packet. When the number of packets at the analyzer port exceeds the bandwidth of the analyzer port, packets are dropped based on the loss priority value. when there is a bandwidth crunch, packets with high loss priority are dropped to clear the congestion. This object uses the following integer values to denote the loss priority:

  • 0–Low loss priority
  • 1–High loss priority

Published: 2010-04-27