Technical Documentation

Intrusion Detection Service Operational Mode Commands

Table 1 summarizes the command-line interface (CLI) commands you can use to monitor and troubleshoot the intrusion detection service (IDS). Commands are listed in alphabetical order.

Table 1: IDS Operational Mode Commands

Task

Command

Clear (set to zero) IDS events and event information.

clear services ids

Clear the IDS events for a particular address that might be under attack.

clear services ids destination-table

Clear the IDS attack source and destination address pair table.

clear services ids pair-table

Clear all IDS events for addresses that are suspected attackers.

clear services ids source-table

Display IDS event information.

show services ids

Note: IDS is supported on the adaptive services interface on the following routers:

  • J Series routers—sp-pim/0/slot
  • M Series and T Series routers—sp-fpc/pic/port

IDS is also supported on the redundant adaptive services interface (rspnumber) on M Series and T Series routers.

Note: For information about how to configure IDS, see the JUNOS Services Interfaces Configuration Guide.


Published: 2010-04-28