[an error occurred while processing this directive][an error occurred while processing this directive]

ES-IS Operational Mode Commands

Table 1 summarizes the command-line interface (CLI) commands you can use to monitor and troubleshoot the End System-to-Intermediate System (ES-IS) protocol. Commands are listed in alphabetical order.

Table 1: ES-IS Operational Mode Commands

Task

Command

Clear ES-IS adjacencies.

clear esis adjacency

Clear ES-IS statistics for packets sent or received.

clear esis statistics

Display ES-IS adjacencies.

show esis adjacency

Display ES-IS interfaces.

show esis interface

Display ES-IS statistics for packets sent or received.

show esis statistics

Note: ES-IS is supported only on J Series routers. For information about how to configure ES-IS, see the J Series Services Router Basic LAN and WAN Access Configuration Guide or the JUNOS Routing Protocols Configuration Guide.


Published: 2010-04-28

[an error occurred while processing this directive]