Technical Documentation

Adaptive Services Interface Operational Mode Command

Table 1 summarizes the command line interface (CLI) commands that you can use to monitor and troubleshoot adaptive services operations.

Table 1: Adaptive Services Interface Operational Mode Commands

Task

Command

(M Series and T Series routers only) Manually revert to the primary adaptive services interface or link services IQ interface, or to switch from the primary to the secondary interface.

request interface (revert | switchover) (Adaptive Services)

Display status information about the specified adaptive services interface.

show interfaces (Adaptive Services)

(M Series and T Series routers only) Display status information about the specified redundant adaptive services configuration.

show interfaces (Redundant Adaptive Services)

(M series, T Series, and MX Series routers only) Display general information about adaptive services and link services intelligent queuing (IQ) interfaces redundancy.

show interfaces redundancy

Note: For information about how to configure adaptive services, see the JUNOS Services Interfaces Configuration Guide.


Published: 2010-04-28