[an error occurred while processing this directive][an error occurred while processing this directive]

switchover-delay

Syntax

switchover-delay milliseconds;

Hierarchy Level

[edit logical-systems logical-system-name protocols l2circuit neighbor address interface interface-name],[edit logical-systems logical-system-name routing-instances routing-instance-name protocols vpls neighbor address],[edit protocols l2circuit neighbor address interface interface-name],[edit routing-instances routing-instance-name protocols vpls neighbor address],

Release Information

Statement introduced in JUNOS Release 9.2.

Description

After the primary pseudowire goes down, specifies the delay (in milliseconds) to wait before the backup pseudowire takes over. You configure this statement for each backup neighbor configuration to adjust the switchover time after a failure is detected.

Options

milliseconds—Specify the time to wait before switching to the backup pseudowire after the primary pseudowire fails.

Default: 10,000 milliseconds
Range: 0 through 180,000 milliseconds

Required Privilege Level

routing—To view this statement in the configuration.

routing-control—To add this statement to the configuration.


Published: 2010-04-28

[an error occurred while processing this directive]