Technical Documentation

Example: Configuring IPv4 Static VLAN Demux Interfaces Over an Aggregated Ethernet Underlying Interface with DHCP Local Server

This example shows how to configure a static IPv4 VLAN demux interface with aggregated Ethernet as the underlying interface. DHCP Local Server configuration enables the association of subscribers to the VLAN demux interface by listing the aggregated Ethernet interface in the DHCP local server configuration.

To configure dynamic subscribers on VLAN demux interfaces:

  1. Enable hierarchical scheduling and VLAN tagging on the underlying interface that you plan to use for any VLAN demux interfaces.
    interfaces {ae1 {hierarchical-scheduler;vlan-tagging;aggregated-ether-options {minimum-links 1;lacp {active;periodic slow;link-protection {non-revertive;}}}}}
  2. Define the gigabit Ethernet interfaces that are part of the aggregated Ethernet interface.
    interfaces {ge-5/0/0 {gigether-options {802.3ad ae1;}}ge-5/2/0 {gigether-options {802.3ad ae1;}}}
  3. Define the demux interface.
    interfaces {demux0 {unit 102 {proxy-arp;vlan-id 103;demux-options {underlying-interface ae1;}family inet {unnumbered-address lo0.0 preferred-source-address 173.16.1.1;}}}}
  4. Define the loopback interface.
    interfaces {lo0 {unit 0 {family inet {address 192.16.1.1/32;}}}}
  5. Configure a dynamic profile for initial subscriber access.
    dynamic-profiles {user-profile {interfaces {"$junos-interface-ifd-name" {unit "$junos-underlying-interface-unit" {family inet;}}}protocols {igmp {interface "$junos-interface-name" {version 3;immediate-leave;promiscuous-mode;}}}}}
  6. Configure the access method used to dynamically create the subscriber interfaces.

    The following stanza specifies the aggregated Ethernet interface (ae1.0) for use with the dynamically-created subscriber interfaces.

    system {services {dhcp-local-server {group myDhcpGroup {authentication {password test;username-include {user-prefix igmp-user1;}}dynamic-profile user-profile;interface ae1.0;}}}}

    Instead of using the aggregated Ethernet interface, you can alternatively specify the specific demux interface (demux0.102) as the device to use with the subscriber interfaces as follows:

    system {services {dhcp-local-server {group myDhcpGroup {authentication {password test;username-include {user-prefix igmp-user1;}}dynamic-profile user-profile;interface demux0.102;}}}}

Published: 2010-04-15