Media Flow Manager Web-Based Interface : System Config : System Config > NTP

System Config > NTP
Configure Network Time Protocol (NTP) options. See ntp for CLI details.
NTP Setup
Enable/disable NTP time synchronization. Click Apply to finish, Cancel to revert to existing configuration. See Figure 50. Click Save at the top of the page to make changes persistent across reboots.
Figure 50 System Config > NTP Page Detail (NTP Setup)
NTP servers
View configured NTP servers; see Figure 51, next. For each:
Server—IP address of the NTP server.
Status—Whether or not the server is currently in use.
Stratum—The hierarchical system this NTP server uses.
Offset (ms)—Whether or not an offset (a degree in milliseconds of difference) of the server’s time is configured.
Reference Clock—How the NTP server is finding its reference (base) clock; INIT means this is configured in the /etc/init.d directory.
Poll Interval (sec.)—How often the server exchanges information with its configured reference clocks.
Last response (sec.)—When the last response from the reference clock was received.
NTP version—The set version of NTP.
Select a server and Remove, Enable, and/or Disable it. Click Save at the top of the page to make changes persistent across reboots. NTP servers are enabled by default.
Figure 51 System Config > NTP Page Detail (NTP Servers)
Add New NTP Server
Enter NTP server IP address, version, and enable/disable. See Figure 52, next.
Figure 52 System Config > NTP Page Detail (Add New NTP Server)

Report an Error
Media Flow Manager Administrator's Guide and CLI Command Reference
Copyright © Juniper Networks, Inc.