Rebooting

You can either reboot or shutdown the software; if you use shutdown, the system does not reboot until it is power-cycled. In the CLI, use these commands; in the Management Console, use the System Config > Reboot page.

1.	From Enable or Configure mode, reboot or shutdown the system.

reload

2.	Set boot parameters; optionally specify from which location the image should boot by default; there are only two locations to choose from so the options are 1 and 2 for location ID. If next is used, set the boot location to be the next one after the one currently booted from.

boot {location <location_ID> | next}

3.	View boot parameters.

boot ?

4.	View current settings.

show boot