About Option 3, Flash Ethernet Port LEDs

If you are at the machine console, you can see which ports have been assigned what by pressing 3 (Flash Ethernet Port LEDs) during the installation.

Option 3 does not provide a way to make the assignments; to make the assignments you need to use option 4 or option 5.

Note! The flashing of the port LEDs works on most ethernet devices; if there is a problem, a warning is printed.

Enter 1, 2, 3, 4, 5 or 6 : 3

Flashing eth leds in this order:

0000:01:00.0,00:15:17:8A:49:90,eth0

0000:01:00.1,00:15:17:8A:49:91,eth1

0000:04:00.0,00:13:72:3C:33:56,eth10

0000:05:00.0,00:13:72:3C:33:57,eth11

Flashing each for 3 seconds, then a 6 second pause, for 3 times

Loop 1

Flashing eth0

Flashing eth1

Flashing eth10

Flashing eth11

Pause

Loop 2

Flashing eth0

Flashing eth1

Flashing eth10

Flashing eth11

Pause

Enter 1 to Reboot to complete the installation.

Enter 2 to Halt. Installation will continue when rebooted.

Enter 3 to Flash ethernet port LEDs.

Enter 4 to Configure ethernet device names interactively.

Enter 5 to Specify devices to use for eth0 and eth1.

Enter 6 to Reset ethernet device naming back to default.

 

Enter 1, 2, 3, 4, 5 or 6 :