Media Flow Controller Web-Based Interface : System Config Tab : System Config > Users

System Config > Users
View, remove, enable, disable, and add new users; plus change existing user passwords.
Active Users
View configured users:
Username—Used for logins.
Full Name—For the user, as configured.
Line—How the user is connected, SSH or Web.
Host—What system this user is configured on.
Idle (seconds)—Time since the last command execution of this user.
User Accounts
For each configured user account:
User—Used for logins.
Full Name—For the user, as configured.
Capability—The privilege level assigned this user. Capabilities are described below.Enabled—Whether or not this user account is enabled. User accounts are enabled by default. Disabling an account makes it inactive (logins are disallowed) but does not delete it from the system.
Select a user account and Remove, Enable, and/or Disable it. Click Save at the top of the page to make changes persistent across reboots. See Figure 35.
Figure 35 System Config > Users Page Detail (User Accounts)
Add New User
To add a new user to Media Flow Manager, you need this information:
User—Login name.
Full YPName—Displays in User Accounts list.
Capability— There are three pre-defined capabilities:
admin—Full privileges (default); in Enable mode all EXEC commands are available.
monitor—Privileges for reading all data and performing all actions, but not for changing any configuration.
unpriv—Unprivileged.
Click Add User to complete operation. Click Save at the top of the page to make changes persistent across reboots. See Figure 36.
Figure 36 System Config > Users Page Detail (Add New User)
Change Password
For each user, admin, cmcclient, cmcrendv, and monitor are default users, set or change the password. May be left empty if no password is required. Click Save at the top of the page to make changes persistent across reboots.

Report an Error
Media Flow Controller Administrator's Guide and CLI Command Reference
Copyright © 2010 Juniper Networks, Inc.