Media Flow Controller Web-Based Interface : System Config Tab : System Config > Routing

System Config > Routing
Set IP Routing parameters, including Default Gateway and Static Routes.
Default Gateway
Enter an IP address and click Set Default Gateway to immediately apply changes; click Save at the top of the page to make them persistent across reboots. See Figure 19.
Figure 19 System Config > Routing Page Detail (Default Gateway)
Static and Dynamic Routes
View all configured static and dynamic routes. A static route is a hard coded (manually defined) path that specifies the route to a certain subnet using a certain path.
Destination—The subnet/path for this static route.
Mask—The netmask for this route.
Gateway—The configured gateway (path to the Internet) for this static route.
Interface—The port configured for this static route.
Active—Whether or not this route is being used currently.
Static—Whether or not this route is static (hard coded).
Select a route and click Removed Selected to immediately apply changes; click Save at the top of the page to make them persistent across reboots.
Add Static Route
Static routes set a path in the routing table for a particular destination. You must know the Destination you want a static route to, the Netmask, Gateway IP address, and Interface to use. Click Add Route to immediately apply changes; click Save at the top of the page to make them persistent across reboots. See Figure 20.
Figure 20 System Config > Routing Page Detail (Add Static Route)

Report an Error
Media Flow Controller Administrator's Guide and CLI Command Reference
Copyright © 2010 Juniper Networks, Inc.