Media Flow Controller Fault Management : Troubleshooting Media Flow Controller : Media Flow Controller Licenses Invalid

Media Flow Controller Licenses Invalid
Media Flow Controller licenses are tied to the MAC address of eth0. Typically you must manually set the eth0 interface at installation with the eth-setup command—option 5 during installation. If not specified, the default assignation of ports is the order in which the drivers are loaded and if eth0 is not assigned an inet address at that time, your licenses may be invalid.
First, determine which interface to use with the following command that shows which interface has an inet address (the last two octets of the HWaddr are what you need).
show interface
Next, type the following command to set that interface as the eth0 management interface.
management interface <interface_ID>

Report an Error
Media Flow Controller Administrator's Guide and CLI Command Reference
Copyright © 2010 Juniper Networks, Inc.