You can either reboot or shutdown Media Flow Controller; if you use shutdown, the system does not reboot until it is power-cycled. In the CLI, use these commands:
2. Set boot parameters; optionally specify a default location from which the image boots; there are only two locations to choose from so the options are 1 and 2 for location ID. If next is used, set the boot location to be the next one after the one currently booted from.boot {location <location_ID> | next}To reboot using the Management Console, go to the System Config tab, Upgrade page; see System Config > Reboot for details.
Report an Error |
Media Flow Controller Administrator's Guide and CLI Command Reference |
Copyright © 2010 Juniper Networks, Inc. |