Media Flow Controller CLI Commands : management

Configure the management interface to be in sync with your licenses and/or eth0. If you re-manufacture and find that your licenses are no good, you may have not gotten the correct interface (one with an IP address) auto-assigned as eth0. You can use this command to set the management interface manually. Use show interfaces to see which interface has an IP address assigned and use the name of that interface. Also, you can use show license, find the MAC address of your license, use show interface to find the interface with that MAC address, and assign that interface as the management interface.
Important! Management interface configuration is not required for Juniper Networks VXA Series engines; it is set in the factory.
management interface <interface_name>

Report an Error
Media Flow Controller Administrator's Guide and CLI Command Reference
Copyright © 2010 Juniper Networks, Inc.