Configuring Device Addresses

You can use the Management tab to configure IPv4 and loopback addresses on the device.

To configure IPv4 and loopback addresses:

  1. In the J-Web user interface, select Configure > System Properties > Management Access.

    Note: After you make changes to the configuration in this window, you must commit the changes immediately for them to take effect. To commit all changes to the active configuration, select Commit Options > Commit. See Using the Commit Options to Commit Configuration Changes (J-Web Procedure) for details about all commit options.

  2. Click Edit. The Edit Management Access dialog box appears.
  3. Select the Management tab.
  4. To enable a loopback address for the device, enter an address and corresponding subnet mask in the Loopback address section.
  5. To enable an IPv4 address for the device, select IPv4 address and enter a corresponding management port, subnet mask, and default gateway.
  6. Click OK to save the configuration or Cancel to clear it.