[Prev][Next][Report an Error]

Monitoring Route Information

To view the routing tables in the J-Web interface, select Monitor > Routing > Route Information (see Figure 39).

Note: After you make changes to the configuration in this window, you must commit the changes immediately for them to take effect. To commit all changes to the active configuration, select Commit Options > Commit. See Using the Commit Options to Commit Configuration Changes (J-Web Procedure) for details about all commit options.

Apply a filter or a combination of filters to display relevant routes. Table 47 describes the different filters, their functions, and the associated actions.

To view the routing table in the CLI, enter the following commands in the CLI interface:

Figure 39: Route Information Page

Route Information

Table 47: Filtering Route Messages



Your Action

Destination Address

Specifies the destination address of the route

Enter the destination address.


Specifies the protocol from which the route was learned.

Enter the protocol name.

Next hop address

Specifies the network layer address of the directly reachable neighboring system (if applicable) and the interface used to reach it.

Enter the next hop address.

Receive protocol

Specifies the dynamic routing protocol using which the routing information was received through a particular neighbor.

Enter the routing protocol.

Best route

Specifies only the best route available.

Select the view details of the best route.

Inactive routes

Specifies the inactive routes.

Select the view details of inactive routes.

Exact route

Specifies the exact route.

Select the view details of the exact route.

Hidden routes

Specifies the hidden routes

Select the view details of hidden routes.


Applies the specified filter and displays the matching messages.

Click Search to apply the filter and display messages.

Table 48 summarizes key output fields in the routing information display.

Table 48: Summary of Key Routing Information Output Fields



Additional Information

Static Route Addresses

The list of static route addresses.



Protocol from which the route was learned: Static, Direct, Local, or the name of a particular protocol.



The preference is the individual preference value for the route.

The route preference is used as one of the route selection criteria.

Next-Hop type

The next-hope type for the route.

If a next hop type is listed as Discard, all traffic with that destination address is discarded rather than routed. This value generally means that the route is a static route for which the discard attribute has been set.

If a next hop is listed as Reject, all traffic with that destination address is rejected. This value generally means that the address is unreachable. For example, if the address is a configured interface address and the interface is unavailable, traffic bound for that address is rejected.

If a next hop is listed as Local, the destination is an address on the host (either the loopback address or Ethernet management port 0 address, for example).


How long the route has been known.



Flags for this route.

There are many possible flags.

AS Path

AS path through which the route was learned. The letters of the AS path indicate the path origin:

  • I — IGP.
  • E — EGP.
  • ? — Incomplete. Typically, the AS path was aggregated.

Route Information

Route Information is shown for the selected route table with the following details: x destinations, x routes (x active, x hold down, x hidden) where x indicates the number of routes for that specific category.


[Prev][Next][Report an Error]