[Prev][Next][Report an Error]

Defining CoS Value Aliases

Figure 21 shows the initial configuration page for defining aliases for class-of-service (CoS) values, and Table 29 describes the related fields. By defining aliases you can assign meaningful names to a particular set of bit values and refer to them when configuring CoS components. For more information about CoS values and aliases, see the Junos OS Class of Service Configuration Guide.

To define CoS value aliases:

  1. Select Configure > Class of Service > Value Aliases.

    Note: After you make changes to the configuration in this window, you must commit the changes immediately for them to take effect. To commit all changes to the active configuration, select Commit Options > Commit. See Using the Commit Options to Commit Configuration Changes (J-Web Procedure) for details about all commit options.

  2. Click one of the following:

Figure 21: CoS Value Aliases Configuration Page

CoS Value Aliases Configuration

Table 29: CoS Value Aliases Configuration Fields



Your Action

Alias name

Specifies the name of the code point; for example, af11 or be.

Enter a name.

Alias type

Specifies a code point type. A code point type can be DSCP or IP precedence.

Select a value.

CoS value bits

Specifies the CoS value for which an alias is defined.

Changing this value alters the behavior of all classifiers that refer to this alias.

To specify a CoS value, type it in an appropriate format:

  • For DSCP CoS values, use the format xxxxxx, where x is 1 or 0; for example, 101110.
  • For IP precedence CoS values, use the format xxx, where x is 1 or 0; for example, 111.

[Prev][Next][Report an Error]