[Prev][Report an Error]

Loading a Previous Configuration File

To load (roll back) and commit a previous configuration file stored on the device:

  1. Select Config Management > History.

    Note: After you make changes to the configuration in this window, you must commit the changes immediately for them to take effect. To commit all changes to the active configuration, select Commit Options > Commit. See Using the Commit Options to Commit Configuration Changes (J-Web Procedure) for details about all commit options.

    A list of the current and previous 49 configurations is displayed as Configuration History in the main pane (see Figure 54). Table 66 summarizes the Configuration History display.

  2. In the Action column, click Rollback for the version of the configuration you want to load.

    The main pane displays the results of the rollback operation.

    Note: When you click Rollback, the switch loads and commits the selected configuration. This behavior is different from the switch's behavior that occurs after you enter the rollback configuration mode command from the CLI. In the latter case, the configuration is loaded but not committed.


[Prev][Report an Error]