[Prev][Next][Report an Error]

Static Routing

Use J-Web configuration to configure static routes.

To configure static routes:

  1. In the J-Web user interface, select Configure > Routing > Static Routing. The Static Routing page displays details of the configured routes (see Figure 16).

    Note: After you make changes to the configuration in this window, you must commit the changes immediately for them to take effect. To commit all changes to the active configuration, select Commit Options > Commit. See Using the Commit Options to Commit Configuration Changes (J-Web Procedure) for details about all commit options.

    Figure 16: Static Routing Page

    Static Routing Page

  2. Click one:

Table 20: Static Routing Configuration Summary

Field

Function

Your Action

Route  

Route

Specifies the default gateway for the switch.

To specify an IPv4 address:

  1. Select IPv4.
  2. Type an IP address; for example, 10.10.10.10.
  3. Enter the subnet mask or address prefix. For example, 24 bits represents 255.255.255.0.

To specify an IPv6 address:

  1. Select IPv6.
  2. Type an IP address; for example, 2001:ab8:85a3::8a2e:370:7334.
  3. Enter the subnet mask or address prefix.

Next-hop

Specifies the next-hop address or addresses to be used when routing traffic to the static route.

To add an address:

  1. Click Add.
  2. In the IP address dialog, enter the IP address.

    Note: If a route has multiple next-hop addresses, traffic is routed across each address in round-robin fashion.

  3. Click OK.

To delete a nexthop address, select it from the list and click Delete.


[Prev][Next][Report an Error]