[Prev][Next][Report an Error]

Configuring Device Addresses

You can use the Management tab to configure IPv4 and loopback addresses on the device.

To configure IPv4 and loopback addresses:

  1. Select Configure>System Properties>Management Access in the J-Web user interface.
  2. Click Edit. Opens the Edit Management Access dialog box.
  3. Select the Management tab.
  4. Enter an address and corresponding subnet mask in the Loopback address section if you want to enable a loopback address for the device.
  5. Select IPv4 address and enter a corresponding management port, subnet mask, and default gateway if you want to enable an IPv4 address for the device.
  6. Click OK.

[Prev][Next][Report an Error]