[Prev][Next][Report an Error]

Configuring an OSPF Network with Quick Configuration

J-Web Quick Configuration allows you to create single-area OSPF networks. Figure 34 shows the Quick Configuration Routing page for OSPF.

Figure 34: Quick Configuration Routing Page for OSPF

Quick Configuration Routing
Page for OSPF

To configure a single-area OSPF network with Quick Configuration:

  1. In the J-Web user interface, select Configuration>Quick Configuration>Routing>OSPF Routing.
  2. Enter information into the Quick Configuration Routing page for OSPF, as described in Table 119.
  3. Click one of the following buttons:
  4. To check the configuration, see the JUNOS Enhanced Services Interfaces and Routing Configuration Guide.

Table 119: OSPF Routing Quick Configuration Summary

Field

Function

Your Action

Router Identification

Router Identifier (required)

Uniquely identifies the router.

Type the device's 32-bit IP address, in dotted decimal notation.

OSPF

Enable OSPF

Enables or disables OSPF.

  • To enable OSPF, select the check box.
  • To disable OSPF, clear the check box.

OSPF Area ID

Uniquely identifies the area within its AS.

Type a 32-bit numeric identifier for the area, or an integer.

If you enter an integer, the value is converted to a 32-bit equivalent. For example, if you enter 3, the value assigned to the area is 0.0.0.3.

Area Type

Designates the type of OSPF area.

From the list, select the type of OSPF area you are creating:

  • regular—A regular OSPF area, including the backbone area
  • stub—A stub area
  • nssa—A not-so-stubby area (NSSA)

OSPF-Enabled Interfaces

Designates one or more interfaces on which OSPF is enabled.

For information about interface names, see the JUNOS Enhanced Services Interfaces and Routing Configuration Guide.

The first time you configure OSPF, the Logical Interfaces box displays a list of all the logical interfaces configured on the device. Do any of the following:

  • To enable OSPF on an interface, click the interface name to highlight it, and click the left arrow to add the interface to the OSPF interfaces list.
  • To enable OSPF on multiple interfaces at once, press Ctrl while you click multiple interface names to highlight them. Then click the left arrow to add the interfaces to the OSPF interfaces list.
  • To enable OSPF on all logical interfaces except the special fxp0 management interface, select All Interfaces in the Logical Interfaces list and click the left arrow.
  • To enable OSPF on all the interfaces displayed in the Logical Interfaces list, click All to highlight every interface. Then click the left arrow to add the interfaces to the OSPF interfaces list.
  • To disable OSPF on one or more interfaces, highlight the interface or interfaces in the OSPF interfaces box and click the right arrow to move them back to the Logical Interfaces list.

[Prev][Next][Report an Error]