[Prev][Next][Report an Error]

Configuring Static Routes with Quick Configuration

J-Web Quick Configuration allows you to configure static routes. Figure 30 shows the Quick Configuration Routing page for static routing.

Figure 30: Quick Configuration Routing Page for Static Routing

Quick Configuration Routing
Page for Static Routing

To configure static routes with Quick Configuration:

  1. In the J-Web user interface, select Configuration>Quick Configuration>Routing and Protocols.
  2. Enter information into the Static Routing Quick Configuration page, as described in Table 106.
  3. From the main static routing Quick Configuration page, click one of the following buttons:
  4. To check the configuration, see the JUNOS Enhanced Services Interfaces and Routing Configuration Guide.

Table 106: Static Routing Quick Configuration Summary

Field

Function

Your Action

Default Route 

Default Route

Specifies the default gateway for the router.

Type the 32-bit IP address of the Services Router's default route in dotted decimal notation.

Static Routes 

Static Route Address (required)

Specifies the static route to add to the routing table.

  1. On the main static routing Quick Configuration page, click Add.
  2. In the Static Route Address box, type the 32-bit IP address of the static route in dotted decimal notation.

Next-Hop Addresses

Specifies the next-hop address or addresses to be used when routing traffic to the static route.

  1. In the Add box, type the 32-bit IP address of the next-hop host.
  2. Click Add.
  3. Add more next-hop addresses as necessary.

    Note: If a route has multiple next-hop addresses, traffic is routed across each address in round-robin fashion.

  4. When you have finished adding next-hop addresses, click OK.

[Prev][Next][Report an Error]