[Prev][Next][Report an Error]

Monitoring RIP Routing Information

To view RIP routing information, select Monitor>Routing>RIP Information, or enter the following CLI commands:

Table 11 summarizes key output fields in the RIP routing display.

Table 11: Summary of Key RIP Routing Output Fields

Field

Values

Additional Information

RIP Statistics

Rip info

Information about RIP on the specified interface, including UDP port number, hold-down interval (during which routes are neither advertised nor updated), and timeout interval.

 

Logical interface

Name of the logical interface on which RIP is configured.

 

Routes learned

Number of RIP routes learned on the logical interface.

 

Routes advertised

Number of RIP routes advertised on the logical interface.

 
RIP Neighbors  

Neighbor

Name of the RIP neighbor.

This value is the name of the interface on which RIP is enabled. The name is set in either of the following ways:

  • In the J-Web configuration editor, on the Protocols>RIP>Group> group-name>Neighbor page
  • In the CLI configuration editor, with the neighbor neighbor-name statement at the [edit protocols rip group group-name] level of the configuration hierarchy

State

State of the RIP connection: Up or Dn (Down).

 

Source Address

Local source address.

This value is the configured address of the interface on which RIP is enabled.

Destination Address

Destination address.

This value is the configured address of the immediate RIP adjacency.

In Met

Value of the incoming metric configured for the RIP neighbor.

 

For more information about the J-Web Monitor task, see Monitor Tasks.


[Prev][Next][Report an Error]