Configuring Destination NAT—Quick Configuration

You can use J-Web Quick Configuration to quickly configure destination NAT.

To configure destination NAT with Quick Configuration:

Select Configuration > Quick Configuration > Firewall/NAT > Destination NAT. See the figure below.
Figure 68: Quick Configuration Page for Destination NAT
Click Add. The Quick Configuration screen for destination NAT appears as shown in the figure below.
Fill in either an IP address range or a single IP address with its port number. See the table below for more information on these options.
Click one of the following buttons:
- To apply the configuration, click OK. The Destination NAT screen appears.
- To cancel your entries and return to the main page, click Cancel.
Click one of the following buttons:
- To add another destination NAT configuration, click Add. You will return to the configuration screen as shown in Figure 68.
- To delete an already configured destination NAT, select the desired dst_NAT from the list and click Delete.
- To apply the configuration and stay on the Quick Configuration page, click Apply.
- To apply the configuration and return to the main Configuration page, click OK.
- To cancel your entries and return to the main page, click Cancel.

Field	Function	Action
Source NAT
Name	Name for the destination NAT.	Specify a name for the destination NAT.
IP Address Range	A range of IP addresses for destination address translation. Multiple address ranges can be specified in a pool.	Specify an address range, a low IP address to specify the start address in the range and a high IP address to specify the end address in the range. For example, 30.1.1.0 to 30.1.1.255.
IP Address	IP address to which destination IP addresses are translated.	Specify an IP address. This can be a fixed IP address for a subnet.
Port	(Optional) Port number to which destination IP addresses are translated.	Specify a port number.

Figure 69: Destination NAT

Destination NAT