Static Configuration Page Options
- Select Configure >NAT>Static in the J-Web
user interface.
The Static NAT configuration page appears. Table 39 explains the contents of this page.
- Click one:
- Add—Adds a new or duplicate static NAT configuration. Enter information as specified in Table 40.
- Edit—Edits the selected static NAT configuration.
- Delete—Deletes the selected static NAT configuration.
- Launch Wizard— Launches the NAT wizard with
static NAT as the default NAT type.
The Launch Wizard option is not supported on high-end SRX Series devices.
- Click one:
- OK—Saves the configuration and returns to the main configuration page.
- Cancel—Cancels your entries and returns to the main configuration page.
Table 39: Static NAT Configuration Page
Field | Function |
|---|---|
| Static NAT Rule Set | |
From | Displays the destination NAT sort options from which the packets flow. The following options are available:
|
Filter | Displays the filter option. |
Name | Displays the name of the static NAT rule set. |
From | Displays the name of the routing instance/zone/interface from which the packets flow. |
Rule | Displays the name of the rule in the selected static NAT rule set. |
Description | Displays a description of the static NAT rule set. |
| Rules in Selected Rule-Set | |
Rule Name | Displays the name of the routing instance/zone/interface to which the packet flows. |
Source Addresses | Displays the match source addresses. |
Source Ports | Displays the match source ports. |
Destination Addresses | Displays the match destination address. |
Destination Port | Displays the match destination port. |
Prefix | Displays the referenced prefixes. |
Mapped Port | Displays the mapped port or port range. |
Upper Threshold | Displays the upper threshold at which an SNMP trap is triggered. |
Lower Threshold | Displays the lower threshold at which an SNMP trap is triggered. |
Action | Displays the action of the rule in the selected rule set. |
Description | Displays a description of the rule in the selected static NAT rule set. |
Table 40: Add Static NAT Configuration Details
| Field | Function | Action |
|---|---|---|
| Add Rule Set | ||
Rule Set Name | Specifies the name of the rule set. | Enter the rule set name. |
Rule Set Description | Specifies a description for the rule set. | Enter a description for the rule set. |
| From | Specifies the filter options. The following options are available:
| Select an option. Select the routing instances/zones/interfaces in the Available column and the use the right arrow to move them to the Selected column. |
| Add Rule | ||
Rule Name | Specifies the name of the rule. | Enter the rule name. |
Rule Description | Specifies a description for the rule. | Enter a description for the rule. |
| Match | ||
Source Address | Specifies the source address to match. | Select a source address name from the list, or enter a source IP address; then click Add . Up to 8 IP addresses and address names are supported. |
Source Ports | Specifies the source port to match. | Select a source port from the list, or enter a source port; then click Add. Up to 8 ports or port ranges are supported. |
Destination Address | Specifies the IP address. The following options are available:
| Enter the IP address. |
Destination Port | Specifies the destination port options. The following options are available:
| Select an option. |
| Then | ||
Host Address | Prefix—Specifies the static prefix. | Enter the static prefix address. |
Mapped Port | Specifies the destination port options. The following options are available:
| Select an option. |
Routing Instance | Specifies the routing instance. | Select a routing instance. |
Upper Threshold | Specifies that an SNMP trap is triggered when the session count for the specific rule falls below the high threshold. | Enter a session number. |
Lower Threshold | Specifies that an SNMP trap is triggered when the session count for the specific rule falls below the low threshold. | Enter a session number. |