Static NAT Configuration Page Options

  1. Select Configure >NAT>Static NAT in the J-Web user interface.

    The Static NAT configuration page appears. Table 39 explains the contents of this page.

  2. Click one:
    • Add—Adds a new or duplicate static NAT configuration. Enter information as specified in Table 40.
    • Edit—Edits the selected static NAT configuration.
    • Delete—Deletes the selected static NAT configuration.
  3. Click one:
    • OK—Saves the configuration and returns to the main configuration page.
    • Cancel—Cancels your entries and returns to the main configuration page.

Table 39: Static NAT Configuration Page

Field

Function

Static NAT Rule Set

From

Displays the destination NAT sort options from which the packets flow.

The following options are available:

  • Routing Instance
  • Zone
  • Interface

Filter

Displays the filter option.

Name

Displays the name of the static NAT rule set.

From

Displays the name of the routing instance/zone/interface from which the packets flow.

Rule

Displays the name of the rule in the selected static NAT rule set.

Description

Displays a description of the static NAT rule set.

Rules in Selected Rule-Set

Rule Name

Displays the name of the routing instance/zone/interface to which the packet flows.

Source Addresses

Displays the match source addresses.

Source Ports

Displays the match source ports.

Destination Addresses

Displays the match destination address.

Destination Port

Displays the match destination port.

Prefix

Displays the referenced prefixes.

Mapped Port

Displays the mapped port or port range.

Upper Threshold

Displays the upper threshold at which an SNMP trap is triggered.

Lower Threshold

Displays the lower threshold at which an SNMP trap is triggered.

Action

Displays the action of the rule in the selected rule set.

Description

Displays a description of the rule in the selected static NAT rule set.

Table 40: Add Static NAT Configuration Details

Field FunctionAction
Add Rule Set

Rule Set Name

Specifies the name of the rule set.

Enter the rule set name.

Rule Set Description

Specifies a description for the rule set.

Enter a description for the rule set.

From

Specifies the filter options. The following options are available:

  • Routing Instance
  • Zone
  • Interface

Select an option.

Select the routing instances/zones/interfaces in the Available column and the use the right arrow to move them to the Selected column.

Add Rule

Rule Name

Specifies the name of the rule.

Enter the rule name.

Rule Description

Specifies a description for the rule.

Enter a description for the rule.

Match

Source Address

Specifies the source address to match.

Select a source address name from the list, or enter a source IP address; then click Add .

Up to 8 IP addresses and address names are supported.

Source Ports

Specifies the source port to match.

Select a source port from the list, or enter a source port; then click Add.

Up to 8 ports or port ranges are supported.

Destination Address

Specifies the IP address. The following options are available:

  • IPv4—The IPv4 destination address to match.
  • IPv6—The IPv6 destination address to match.

Enter the IP address.

Destination Port

Specifies the destination port options. The following options are available:

  • Any
  • Port
  • Port Range

Select an option.

Then

Host Address

Prefix—Specifies the static prefix.

Enter the static prefix address.

Mapped Port

Specifies the destination port options. The following options are available:

  • Any
  • Port
  • Port Range

Select an option.

Routing Instance

Specifies the routing instance.

Select a routing instance.

Upper Threshold

Specifies that an SNMP trap is triggered when the session count for the specific rule falls below the high threshold.

Enter a session number.

Lower Threshold

Specifies that an SNMP trap is triggered when the session count for the specific rule falls below the low threshold.

Enter a session number.

Related Documentation