Chassis Cluster Setup Configuration Page Options

  1. Select Configure>Chassis Cluster>Setup.

    The Chassis Cluster Setup configuration page appears. Table 171 explains the contents of this page.

  2. Click one:
    • Enable—Enables cluster mode on the node.
      • Enable and Reboot—Enables cluster mode and reboots the node.
      • Enable and No Reboot—Enables cluster mode without rebooting the node.
    • Disable—Disables the cluster mode on the node.
      • Disable and Reboot—Disables cluster mode and reboots the node.
      • Disable and No Reboot—Disables cluster mode without rebooting the node.
    • Reset—Resets your entries to the original value.
  3. Click one:
    • OK—Saves the configuration and returns to the main configuration page.
    • Commit Options>Commit—Commits the configuration and returns to the main configuration page.
    • Cancel—Cancels your entries and returns to the main configuration page.

Table 171: Add Chassis Cluster Setup Configuration Details

Field FunctionAction

Cluster ID

Specifies the number by which a cluster is identified.

Enter a number from 0 through 15.

Node

Node ID

Specifies the number by which a node is identified.

Enter a number from 0 through 1.

Node Management IP Address (fxp0.0)

Specifies the management IP address of a node.

Enter a valid IP address for the management interface.

Control Link

Fpc

Specifies the FPC control link.

Select the FPC number from the list.

Port

Specifies the port to configure for the control link.

Enter a number from 0 through 2.

Related Documentation